4000U USB Controller (Discontinued March 2006)
规格
-
技术
产品料号
E14603-000
技术
accutouch
尺寸
2.36" x 3.51" x 0.61" / 59.94 mm x 89.03 mm x 15.44 mm
接口
USB High Speed
Plug and play compatible分辨率
Approximately 4096x4096, size independent, 255 levels of Z (pressure)
Conversion Time
Approximately 20 ms per coordinate set
电源
120 mA, typical at +5 VDC
输入电压
+5 VDC, nominal (+4.75 to +5.25 VDC)
波特率
+4.75 to +5.25 VDC
Reliability
MTBF greater than 500,000 hours per MIL-HDBK-217-F2 using the parts stress calculation method for the ground benign environment with an ambient temperature of 35°C
Construction
Four-layer surface-mount design with internal ground plane for EMI suppression
Flammability
The printed circuit board substrate is rated 94V0. All plastic components, such a headers and connectors, are also rated 94V0
Shock and Vibration
Three axis sine wave, 50Hz to 2kHz, 1G, 2 minutes/Octave with dwell on resonance
ESD
Per EN 6100-4-2 1995: Level 4. Contact discharge 8kV, air discharge 15kV
LED Diagnostic Characteristics
A green LED (D2) indicates controller status as follows:
LED Blink Rate: Once per second
Function: Normal condition, untouched state
LED Blink Rate: On continuously
Function: Touched state
LED Blink Rate: Twice per second
Function: Error detected
A second LED (D1) indicates USB status as follows:
LED State: OFF
Function: Controller is not enumerated on USB
LED State: ON
Function: Controller is enumerated on USB, but there is no data transfer
LED State: Blinking
Function: USB data transfers between controller and host are occurringOrientation for USB Communication
P2 pin #: 1 / Signal name: VBUS / Standard wire color: RED
P2 pin #: 2 / Signal name: D- / Standard wire color: WHITE
P2 pin #: 3 / Signal name: D+ / Standard wire color: GREEN
P2 pin #: 4 / Signal name: GND / Standard wire color: BLACK
P2 pin #: Shell / Signal name: Shield / Standard wire color: Drain Wire工作温度
-20°C to 70°C
操作环境
CarrollTouch SmartSet protocol
Initial/Stream/ Untouch/ Z-axis Enable Modes储存温度
-48°C to 85°C
湿度
Operating: 10% to 90% RH, noncondensing
Storage: 10% to 90% RH, noncondensing高度
10,000 feet
MTBF
50,000小时演示
机构认证
Elo controllers are "CNR/USR" UL Recognized Components for USA and Canada, Category NWGQ2, Information Technology Equipment Including Business Equipment.
Elo controllers are TUV Bauart certified as components.
Elo controllers have been tested for compliance with FCC Part 15 Class B limits
Depending on the application, it may be necessary to pay special attention to system grounding and shielding, and it may be necessary to apply ferrite suppressor beads.
RoHS Declaration of Compliance安装选项
All mounting holes are plated through-holes for chassis ground connection. Refer to the drawings at the end of this document
Connectors and Pin Definitions
The connector configuration permits the controller to be placed in-line between the touchscreen and a USB hub or host attachment.